Precision-flight Elevator Potentiometer Bedienungsanleitung PDF herunterladen

1. Make sure that the Elevator trim wheel is in the T/O position.

2. Disconnect power to the cockpit.

3. Remove cowling cover.

4. Disconnect power connection to exhaust fans (if applicable.)

5. Remove screws on the black cover (10 total). There are screws on both left and right sides, all of them

will need to be removed.

Elevator Potentiometer Replacement

Guide

1 2 3 4

Seite 1

1. Make sure that the Elevator trim wheel is in the T/O position. 2. Disconnect power to the cockpit. 3. Remove cowling cover. 4. Disconnect

Seite 2

If you do not have the access panel, you will need to remove the 12 screws holding full back cover. 6. Once cover is removed, you will have access

Seite 3

7. Using a ½ inch wrench, remove the bridge bolt. (see picture above) 8. Using a 7/16 wrench, remove the Z bracket bolt. (see above) 9. Cut the wi

Seite 4

Determining the potentiometer you have: 13. Using the reference picture below you will either have the 250K potentiometer (left) or 10K potentiometer

Keine Kommentare

Precision-flight Elevator Potentiometer Bedienungsanleitung